Well I’m back from a short hiatus — I took a little time off to hang out with my boys during their winter break. I’m trying to get back into the swing of blogging, but with a newborn baby at home, my posts might be sporadic for a while. Anyway, back when I temporarily lost my mind — aka was nesting like a mad woman — and decided that our entryway needed a makeover, one of the things I wanted to incorporate was a wall-mounted coat rack.

We don’t have a coat closet — the previous owners added shelving and converted it into a second pantry since it’s randomly in the kitchen, and we haven’t converted it back. I decided to build a simple coat rack to hang above the new bench. (You can find the bench plans and tutorial here.)

Here’s how to build a wall mounted coat rack — it’s very easy!

HOW TO BUILD A WALL MOUNTED COAT RACK

What you’ll need for this project:

(Disclosure: Affiliate links included. As an Amazon Associate I earn from qualifying purchases.)

1×6 cut to 54″ long (or length of your choice)
5 Coat Hooks (I used oil-rubbed bronze from D. Lawless Hardware)
Drill
Screwdriver
Primer and paint of your choice, or stain (I used Sherwin Williams Alabaster in semi-gloss)
Paintbrush
Foam Roller
Wood Screws or Wall Anchors and screws
Miter Saw or Circular Saw (or you can have your 1×6 cut to length at The Home Depot when you buy it)
Measuring tape
Pencil
Sander
RYOBI Multi-Tool/Duct Tape/or Shorter screws for the coat hooks (see Step 6)

Step 1:

Cut your 1×6 to 54″ inches long (or length of your choice), or have your wood cut for you when you purchase it at The Home Depot.

Step 2:

Sand the wood.

Step 3:

Place the coat hooks 9 inches apart, center the hooks on the board, and use a pencil to mark the holes. Then, drill pilot holes where the coat hooks will go.

Step 4:

Prime and paint the wood. (Or stain it.) I use a combo of a paint brush for the edges and a foam roller. You can seal it with Minwax Finishing Paste for extra protection if you choose to.

Step 5:

Use a screwdriver to attach the coat hooks, inserting the screws into the pre-drilled pilot holes.

Step 6:

The screws that came with my coat hooks were just a teensy bit too long and protruded out the back of the wood just a bit.

I used a RYOBI Multi-tool to cut the tips of the screws off so they wouldn’t scratch the wall, and then I covered them with tiny pieces of duct tape for added protection. You could purchase shorter screws instead, but I couldn’t find the color I needed so I just improvised.

Step 7:

Drill directly into wall studs, or use wall anchors. If you prefer for the screws to not be visible, you can countersink them and then use wood filler and paint to cover them up.

Another option is to use D-Rings and wall anchors, which is how I chose to hang mine since I didn’t want the screws to be visible.

That’s it! Pretty simple. This is a great beginner project since it doesn’t require complex cuts, and you could use a regular handsaw instead of a miter saw if you wanted to.

Disclosure: This post contains affiliate links.

YOU MIGHT ALSO ENJOY THESE POSTS:

Connect with me here: